Sabtu, 02 April 2016

Build an Aquaponics Grow Bed

Posted on 08.16 by imig



All the food CCRES produced during the year is given to poor families.

  • Measure the length and width of the aquarium with the measuring tape.
  • Cut the plywood with the saw to the dimensions of the aquarium you measured in Step 1.






  • Cut four beams the same length and width of the plywood you cut in Step 2.
  • Drill holes into two beams and screw them together at a 90-degree angle. Lay the other two beams across the aquaponics grow bed.
  • Cut legs for the aquaponics grow bed frame. Place the frame where you will use it and measure and cut the legs to the length you need, keeping in mind the need to make them longer if there is a slope.
    • src="https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEhyNAWNKfua2a1xNebHgV_CiUlP3jTcGJic2h2JSJbLjto-l8TBkFEHyFZbseoPInjZpa-NpaHvlJ9IQLrHr861It_7ztZL2FZbH9f1yIZgX-LYmclP2DfJFxULUk_7O997GxaES4yyppRd/s320/rujan+2011+433.JPG" width="320">
  • Drill holes into the legs. Keep them flush with the edge of the frame and screw them into place securely. Place the frame onto the plywood you cut in Step 2.  

     
  • Place the grow bed right next to the aquarium or pond. Line the grow bed with pond foil the same length and width of the grow bed. Pour gravel on top of the pond foil in the grow bed. Cut a hole through the center of the grow bed and pond foil with the saw.
  • Place the water pump in the fish tank or pond and connect the water-in pipe to the pump.
     Pull the water-in pipe through the hole in the grow bed. Install the overflow drain into the grow bed and set it to a few inches above the height of the grow bed to prevent water from overflowing.
  • Fill the aquarium or pond with water and place plants into the gravel of the grow bed.
    •  
    CCRES AQUAPONICS special thanks to Zeljko Serdar for presentation of “How-To” module.

    Related Posts by Categories

    0 komentar:

    Posting Komentar

    Langganan: Posting Komentar (Atom)